StreamLive Pro

How to live stream a music performance with good sound

Live stream a concert or a music performance with good sound: take audio from the mixer, switch off voice processing, set levels, and send it to several networks.

Updated November 5, 2026 · 5 min read

A music live stream is judged by its sound first. Viewers forgive a soft picture; they leave when the music pumps, cuts out or sounds like a phone call. Most of that comes from one thing: tools made for video calls treat music as noise and try to clean it. This guide covers where to take the sound from, which processing to switch off, how to set levels, and how to send one stream to several networks with StreamLive Pro.

The short version

1. Take the sound from the mixing desk, not from a microphone in the room.
2. Bring it into the computer through an audio interface.
3. Switch off noise suppression for music.
4. Set the level so the loudest song peaks well below the maximum.
5. Check with headphones, then go live to every network from one upload.

Choose your setup

The hall mix and the stream mix are different. In a hall, a loud drum kit and amplifiers fill the room by themselves, so the desk sends little of them to the speakers. A stream hears only what the desk sends, so the desk feed can sound thin and vocal-heavy. If the sound engineer can spare an auxiliary output, ask for a separate stream mix.

Step by step

1. Get the sound into the computer

Connect the desk's output to a USB audio interface, and the interface to the computer. In the StreamLive Pro browser studio choose the interface as the microphone in Camera & Mic. Known multichannel interfaces (for example Focusrite, Behringer, PreSonus, RME, MOTU and similar) are opened as raw input: echo cancellation, noise suppression and automatic gain are not applied to them.

2. Switch off noise suppression

For an ordinary microphone, the browser studio uses a speech profile with echo cancellation and noise suppression, which is right for talking and wrong for music: sustained notes, cymbals and quiet passages can be cut or smeared. In the studio, switch the noise suppression button off when the sound is music. Use headphones for monitoring so the speakers do not feed back into the microphone.

3. Set the level

Play the loudest song of the set during the sound check and watch the meter. Leave clear room at the top: the loudest moment should not touch the maximum. The Mic volume slider in Camera & Mic adjusts the input from 0 to 200%, but fix a weak signal at the desk or the interface first; boosting a weak signal in software raises its noise too.

4. Pictures

One wide camera that shows the whole stage is the safety shot. A phone on a stand can be a second camera: open the camera link on the phone, or scan the QR code, and it joins the studio as another input. Prepare the next shot in Preview and press Take to put it on air (Preview and Program explained). Concert light changes fast; lock the camera's exposure if it allows it.

5. Destinations

Connect the networks once in Connections. YouTube needs live streaming enabled on the channel, and the first time can take up to 24 hours. Facebook streams to a Page you manage. Instagram and TikTok give a stream key that changes per session, so paste a fresh one before each show. Your computer uploads one stream, and StreamLive Pro sends it to every network you ticked; see How to live stream to several platforms at once.

6. Encoder settings, if you use OBS or vMix

Follow the network's own numbers. For audio, YouTube recommends AAC, 44.1 kHz and 128 Kbps for stereo (YouTube encoder settings). Send the encoder's output to the StreamLive Pro RTMP, RTMPS or SRT address: Connect OBS to StreamLive Pro.

7. Test, then go live

Do a private test the day before with the same cables and the same room. Listen to the test recording on headphones and on a phone speaker. On the day, start a few minutes before the first song with a holding picture.

Rights and copyright

Networks scan live streams for music owned by others. YouTube says live streams can be interrupted, replaced with a placeholder image or ended when third-party content is matched, even when you have licensed it (Copyright issues with live streams). Original music is the safe case. For covers, check the network's rules and your rights before the show, and keep a short spoken introduction ready in case the stream is interrupted.

Common mistakes

• Microphone in the hall instead of the desk feed. The stream gets room echo and crowd noise. Take the desk output.
• Noise suppression left on. Quiet passages disappear and sustained notes wobble. Switch it off for music.
• No headroom. The loudest chorus distorts. Set the level on the loudest song.
• Speakers instead of headphones for monitoring. Feedback, or the speaker sound recorded twice.
• Old Instagram or TikTok key. It works for one session only. Paste a fresh key before each show.
• Forgetting to record. A recording is kept only if you press Record; otherwise it is removed about two hours after the broadcast.

Where StreamLive Pro fits

StreamLive Pro sends one stream from your browser studio, or from OBS or vMix on a paid plan, to YouTube, Facebook, Instagram, TikTok and other networks together. Press Record to keep the full show. After the broadcast, Shorts are cut from it automatically; the AI can pick weak moments, and a show that is nearly all music gives it less to go on, so check the picks and cut your own moments in the editor if needed (Cut and split clips in the editor). 4K recording is on Pro and Studio. Plans and limits: /pricing?lang=en.

Frequently asked questions

How do I get good sound when I live stream a concert?

Take the sound from the mixing desk through an audio interface, switch off noise suppression, and leave headroom on the loudest song. Monitor on headphones.

Why does my music sound strange in a browser live stream?

The browser applies speech processing to ordinary microphones: echo cancellation and noise suppression. Switch noise suppression off in the studio, or use an audio interface, which is opened without that processing.

Can I stream a show to YouTube and Facebook at the same time?

Yes. Connect both in Connections, tick both before you go live, and StreamLive Pro sends your one stream to each. Facebook must be a Page you manage.

Will YouTube stop my stream because of the music?

It can, if it matches music owned by others, even with a licence according to its help page. Original music is the safe case.

Can band members play together from different places?

Not in time with each other. Internet delay is too long for musicians to play together live; remote guests suit talking parts such as interviews between songs.

Keep reading